NCE 25 - Power Cab DCC Starter System - 2 Amps

Power Cab DCC Starter System - 2 Amps An entire DCC system in the palm of your hand! The Power Cab system can operate one or two HO locomotives. Installation is a snap. Hook two wires to your track and plug in the cab. Then you are off and running trains! The Power Cab kit contains: - Power Cab - 7ft Power Cab Cable - PCP Power Panel - Power Supply - Pro Cab Coiled Cord - Manual The Power Cab represents an Entry Level starter system for small layouts but has all the same features as the high end 5 amp PH-Pro. Its limitations are found in the number of expansion options it can connect to and support. The PowerCab is well-liked because it is a full featured NCE DCC system with a true programming track output capability designed to handle Sound Decoders without any programming issues. Some people with a 5 and 10 amp PH-Pro system purchase a Power Cab system for the full programming track capability and to add an additional throttle for the layout. The Power Cab offers the best Programming Track capability of all the NCE systems. It offers a safe low current programming track output mode where it is safe to test decoders. At the same time, the programming track current from the Power Cab has been raised enough to accommodate the special needs of sound decoders which can have problems working properly with older style programming track outputs. No 3rd party programming track booster is required when using a Power Cab. Up to 256 turnouts can be DCC controlled using DCC accessory turnout decoders. They can be controlled from the PowerCab throttle or any NCE throttle with an accessory control button. The Power Cab allows you to add up to 3 NCE cab bus based accessory devices to the system using 3 special cab addresses. This does NOT take away from the number of throttles [6] you can use with the Power Cab system.